Aastra ATP-CNX-040-01 Uživatelský manuál stáhnout pdf (Strana 27)

Startup and check the Aastra CNX

ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07 1-9

Aastra CNX Installation and Setup Procedures

Startup and check the Aastra CNX

Apply power to the Aastra CNX

To start up the Aastra CNX, insert the CompactFlash card into slot 1 of the unit

and apply power from the power source.

Powering up a new Aastra CNX:

• Starts diagnostic test routines on the Aastra CNX.

• Checks for a flash memory card in CompactFlash slot 1 of the Aastra CNX

chassis.

• Initializes the Aastra CNX and, if successful, resets all LEDs to their normal

state.

• Starts a one-time software script that allows you to setup your network

settings (See Step 7, “Configure the network settings.”)

Check the LEDs

To check the Aastra CNX LEDs:

Step Action

a Check the common LEDs on the front panel. The Power and Status LEDs should

be ON (green) indicating the Aastra CNX is ready to take calls.

b Check the ENET LEDs on the front panel. If your Aastra CNX has a physical

Ethernet link to your network from the 10/100 ENET ports 1 or 2 on the back

panel, and no alarms are present, the ENET LEDs 1 and/or 2 should be ON

(green).

Note: The ENET LEDs FLASH (green) when there is Rx/Tx activity.

c The T1/E1 ports are disabled by default in the Aastra CNX software configuration.

The top row of T1/E1 LEDs should be OFF. To enable these ports and check the

LEDs, the System Administrator must enable the T1/E1 ports using the Aastra

CNX GUI.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 189 190

Žádné komentáře

Aastra ATP-CNX-040-01 Uživatelský manuál Strana 27